I am experiencing uneven cell distribution, where cells do not attach to certain areas of the well, while they attach and grow normally in other areas. How can I resolve this issue?
The issue could be caused by one or more of the following factors:
- Coating concentration too low: The coating concentration may be insufficient for your specific cell line. Try increasing it to 10 μg/mL. Once the cells are adapted to the Biolaminin 521 matrix, you can attempt to reduce the coating concentration to 5 μg/mL.
- Insufficient coating volume: This issue is often seen in smaller well sizes due to surface tension. For 24-well plates, 500 μL of coating solution per well should be sufficient for even coverage. For 6-well plates, at least 1 mL should be used.
- Coating solution drying before cell seeding: If the coating dries out before cell seeding, it will inactivate and fail to support cell growth. This can happen if the coating volume is inadequate or if there is too much time between the exchange of coating solution and culture medium. To prevent this, seal the plate during overnight coating in the fridge. If using a quick coating at 37°C, do not leave the plate for more than 3 hours to avoid drying out.
- Uneven cell seeding: Ensure that the cells are evenly distributed during the seeding process. Gently rock the plate side-to-side after seeding to achieve an even cell spread.
- Issue with cultureware: The problem may also lie with the cultureware itself. Biolaminin coating has been tested and shown to work well on tissue culture plates from brands such as Falcon, Sarstedt, and Corning.